Hi all,
I am at the very basic first steps with microcontrollers and have spent hours and hours now reading online ressources.
I scanned the rflink HP, also the related wiki.
As far, as I understood, I can use an Mega2560 with an RFB6 to enable my linux PC to scan and connect some RF (433MHz) devices I have here and to integrate them into my smarthome solution.
That is my target application, reading some remote thermometer, take over controlling some shuts.
There is a lot of detail information availlable, but unfortunately not much for beginners, like p.e. a step by step tutorial for setting up/building an usb device.
Only things I found was some ways to do RFLink with raspberry PI and a lot of outdated stuff(2007 and beyond).
So do you maybe have some good links or document for me, that describes the basic way to build and flash a mega2560 to use it as usb dongle with Linux?
Best regards
iobn
Begginers' documentation not really availlable, right?
Moderators: rtenklooster, Voyager, BertB, Stuntteam
-
- New user
- Posts: 3
- Joined: 08 Dec 2023, 12:07
Re: Begginers' documentation not really availlable, right?
Did you check out: https://www.rflink.nl/index.php
it has a step by step introduction to the world of home automation..
it has a step by step introduction to the world of home automation..
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Who is online
Users browsing this forum: No registered users and 3 guests