Wiegand-26

From Let's Control It
(Redirected from RFID)
Jump to: navigation, search

Introduction

The ESP can also be used to read out RFID Tag Readers that are using the Wiegand-26 protocol.

The RFID reader has to be connected to two GPIO pins on the ESP module. The ESP uses an interrupt routine to decode the Wiegand-26 bitstream. The RFID reader will send a message to your Home Automation controller containing the unique RFID Tag ID.

Hardware

WiegandRFID 1.jpg RFIDTags.png

The Wiegand-26 RFID TAG Reader can be found on eBay. Please note that the outputs uses 5 volts signals and they should not directly be connected to the ESP. Use a level shifter!

This is just a sample of an RFID reader using the Wiegand-26 protocol.

This Wiegand-26 RFID Reader works with tags compliant with EM4001 ISO standard, on a frequentie of 125kHz.

Connections

WARNING: The unit uses 5 volt signals that can not be used on the ESP module. You must use a levelshifter!!!

The reader needs at least 6 volts. Do not connect VCC to the VCC on the ESP!!! (The unit will turn on at 5 volts, the led will turn on, but detection of RFID tags will fail!)

 Wiegand 	ESP-01
 Black 	GND
 Red   	6-12 Volt
 Green		GPIO 0 (via levelshifter!!!)
 White		GPIO 2 (via levelshifter!!!)

Software

Custom Sketch

todo

ESP Easy

Use the device tab on the ESP Easy webinterface and create a new task by editing one of the available tasks. Select "RFID Reader" from the dropdown box.

EasyConfigRFID.png

Enter the IDX found in the Domoticz device page. Also select the two GPIO pin that you have used to connect the reader. That should be all.

Optional settings

Use of value names