Difference between revisions of "Analog"
Jump to navigation
Jump to search
m (→Introductie) |
|||
| Line 27: | Line 27: | ||
[[ EasyValueNames | Use of value names]] | [[ EasyValueNames | Use of value names]] | ||
| + | |||
| + | === Examples === | ||
| + | [[ Analog pressure | Analog pressure gauge]] | ||
== ESP Connexio == | == ESP Connexio == | ||
Revision as of 12:57, 10 September 2016
Contents
Introduction
The ESP module can read an analog signal and send its value to your controller.
The input signal needs to be connected to the ADC (also referred as Tout) pin on the ESP module. On the ESP-01, this pin is not available.
Hardware
Connect a switch between ground and the ADC pin.
Software
Custom Sketch
ESP Easy
Use the device tab on the ESP Easy webinterface and create a new task by editing one of the available tasks. Select "Analog Input" from the dropdown box.
Enter the IDX found in the Domoticz device page. That should be all.
