Difference between revisions of ""CO2 Sensor MH-Z19""
Jump to navigation
Jump to search
(Created page with "= Introduction = '''This Plugin in currently only available in the latest build on [https://github.com/letscontrolit/ESPEasy/tree/mega github], but should in the next official...") |
|||
| Line 10: | Line 10: | ||
The sensor needs to be connected this way: | The sensor needs to be connected this way: | ||
| − | Function: Pin MH-Z19 ESP8266 | + | Function: Pin MH-Z19 ESP8266 |
| − | VCC | + | VCC 6 3.3V |
| − | GND | + | GND 7 GND |
| − | RX | + | RX 2 1st GPIO specified in Device-settings |
| − | TX | + | TX 3 2nd GPIO specified in Device-settings |
= Software = | = Software = | ||
Revision as of 21:11, 6 April 2017
Introduction
This Plugin in currently only available in the latest build on github, but should in the next official release
The ESP module can read the MH-Z19 CO2 Sensor reading the serial protocol.
Hardware
This Sensor can be bought from Aliexpress:
The sensor needs to be connected this way:
Function: Pin MH-Z19 ESP8266 VCC 6 3.3V GND 7 GND RX 2 1st GPIO specified in Device-settings TX 3 2nd GPIO specified in Device-settings
Software
Plugin is based upon SenseAir plugin by Daniel Tedenljung info__AT__tedenljungconsulting.com Additional features based on https://geektimes.ru/post/285572/ by Gerben (infernix__AT__gmail.com)
ESP Easy
Use the device tab on the ESP Easy webinterface and create a new task by editing one of the available tasks. Select "NDIR CO2 Sensor MH-Z19 [TESTING]" from the dropdown box.
Select the GPIO Ports where you connected the RX and TX lines to.
