Buzzer (RTTTL)

Introduction

RTTTL (Ring Tone Transfer Language) was developed by Nokia to play more "easy on the ear" melodies as ringtones for mobile phones. The tunes over all characteristics are created by using three different commands:

• d - duration
• o - octave
• b - tempo (beat)

After that the actual tune is then created using standard notes (a, b, c, d, e, f, and g), before the note the duration is set, after the note the octave is set:

<duration><note><octave>

To compose a jingle you separate the notes with a comma.

Hardware

You can use a buzzer speaker or a piezo element to play tones.

The wiring is pretty simple, for the buzzer:

For piezo element:

ESP Easy

No device is needed, generally you use rules to activate different notifications, or you send commands to activate them. Below you find more information on how to do this.

Melodies and ringtones

From ESPEasy v2.0.0-dev6 (in the testing plugin set) its also possible to play melodies via [RTTTL]

(don't forget to remove the spaces)

http://<ESP IP address>/control?cmd=rtttl,14:d=8,o=5,b=180,c6,b,c6,p,g,g-,p,f,b,c6,p,d6,p,g,p,c6,b,c6,p,d6,p,f,g,g-,4p,g,f,4d-

This plays a melody on pin 14.

You can also use these from rules. We use it to let our alarm system give feedback to the user via a piezo speaker.

To make a boot-sound on startup, create a rule like this:

On System#Boot do 
  rtttl,14:d=10,o=6,b=180,c,e,g
endon

Tones

Besides RTTTL it's also possible to play a single tone on a pin, via a speaker or piezo element:

http://<ESP IP address>/control?cmd=tone,14,1300,200

Plays a 1300 hz tone for 200 ms on gpio-14h