Difference between revisions of "Switch"
| Line 27: | Line 27: | ||
You can also select between Switch and Dimmer. If you want the ESP Easy to set a fixed dimmer value to the controller, select Dimmer on this dropdown: | You can also select between Switch and Dimmer. If you want the ESP Easy to set a fixed dimmer value to the controller, select Dimmer on this dropdown: | ||
| − | [[File: | + | [[File:EasyConfigSwitchType.png]] |
Click Submit and an additional field will be shown to enter the dimmer set value: | Click Submit and an additional field will be shown to enter the dimmer set value: | ||
| − | [[File: | + | [[File:EasyConfigSwitchDimmer.png]] |
Instead of a conventional state or latching push button, you could also use a momentary push button switch. In this case the ESP Easy will toggle between on/off. | Instead of a conventional state or latching push button, you could also use a momentary push button switch. In this case the ESP Easy will toggle between on/off. | ||
| − | [[File: | + | [[File:EasyConfigSwitchButton.png]] |
| + | |||
| + | Push Button Active Low: Action if input pin tied to ground | ||
| + | |||
| + | Push Button Active HIGH: Action if input pin tied to VCC (3V3) | ||
== ESP Connexio == | == ESP Connexio == | ||
Revision as of 08:07, 3 October 2015
Introductie
The ESP module can read a basic switch to send a state or dimmer value to your controller.
The input switch needs to be connected to a configurable GPIO on the ESP module.
Hardware
Connext a switch between ground and the GPIO pin.
Software
Custom Sketch
ESP Easy
Use the device tab on the ESP Easy webinterface and create a new task by editing one of the available tasks. Select "Switch Input" from the dropdown box.
Enter the IDX found in the Domoticz device page. Also select the GPIO pin that you have used to connect the switch device. That should be all for a default switch.
Other settings:
You can also select between Switch and Dimmer. If you want the ESP Easy to set a fixed dimmer value to the controller, select Dimmer on this dropdown:
Click Submit and an additional field will be shown to enter the dimmer set value:
Instead of a conventional state or latching push button, you could also use a momentary push button switch. In this case the ESP Easy will toggle between on/off.
Push Button Active Low: Action if input pin tied to ground
Push Button Active HIGH: Action if input pin tied to VCC (3V3)
