Difference between revisions of "SHT1X"
Jump to navigation
Jump to search
| Line 18: | Line 18: | ||
[[File:EasyConfigSHT1X.png]] | [[File:EasyConfigSHT1X.png]] | ||
| − | Enter the IDX found in the Domoticz device page. That should be all. | + | Enter the IDX found in the Domoticz device page. Select the two GPIO pins that are connected to the module. |
| + | That should be all. | ||
=== Optional settings === | === Optional settings === | ||
Revision as of 16:33, 10 August 2016
Contents
Introduction
The ESP module can read a SHT1x temperature/Humidity sensor using it's custom protocol.
Hardware
The SHT1x sensor needs to be connected to two selectable GPIO pins. These pins can be configured on the hardware tab.
Software
Custom Sketch
ESP Easy
Use the device tab on the ESP Easy webinterface and create a new task by editing one of the available tasks. Select "Temperature & Humidity - SHT1X" from the dropdown box.
Enter the IDX found in the Domoticz device page. Select the two GPIO pins that are connected to the module. That should be all.
