ESP-01
Revision as of 23:33, 2 December 2017 by Grovkillen (talk | contribs) (Created page with "= Introduction = The ESP-01 is one of the smallest units available. Compared to other ESP units it is powered directly and thus need to be fed with 3.3V and not 5V. Two gener...")
Introduction
The ESP-01 is one of the smallest units available. Compared to other ESP units it is powered directly and thus need to be fed with 3.3V and not 5V. Two general GPIOs are available and if you need more you can use the two serial ports (1,3 / RX,TX).
Hardware
- ESP chip version: ESP8266
- Flash size: 1M
- Onboard USB-TTL converter: No
- GPIO's broken out/available to free use: 0, 2
- Power supply information: 3.3VDC
- Antenna: onboard PCB antenna
Wiring/flashing
A programmer is needed to flash this device.
Programmer ESP TX <--> RX RX <--> TX Power 3.3V <--> VDD GND <--> GND
In order to get the unit in flash mode the GPIO-0 needs to be LOW and the CH-EN need to be set to high. The CH-EN can be connected to the VDD, in the pictures a jumper is soldered between these but you could use a resistor to make sure that no over current hurt the unit.
