ESPEasy Command Reference

ESP Easy Command Reference

You can send all commands supported by the various plugins. There should be no difference between using http or mqtt. There is also a command to trigger an event: event <event>

If you want to run internal commands, you can use rules and trigger this with an event

Command	Class	Purpose	Syntax
Debug	Internal	Change debug level	Debug <1-4>
GPIO	Plugin	Direct control of output pins	See:GPIO
IP	Internal	Change IP address	IP <IP address>
LongPulse	Plugin	Direct pulse control of output pins	See:GPIO
Pulse	Plugin	Direct pulse control of output pins	See:GPIO
PWM	Plugin	Direct PWM control of output pins	See:GPIO
Reboot	Internal	Reboot the ESP	Reboot
Reset	Internal	Reset config to factory default	Reset
Save	Internal	Save config to persistent flash memory	Save
Servo	Plugin	Direct control of servo motors	See:GPIO
Settings	Internal	Show settings on serial terminal	Settings
WifiAPKey	Internal	Change AP WPA key	WifiAPKey <WPA key>
WifiConnect	Internal	Connect to configured wireless network	WifiConnect
WifiDisconnect	Internal	Disconnect from wireless network	WifiDisconnect
WifiKey	Internal	Change WPA key	WifiKey <Wifi WPA key>
WifiScan	Internal	Scan Wireless networks	WifiScan
WifiSSID	Internal	Change SSID	WifiSSID <SSID>