Sonoff Touch

Introduction

The Sonoff Touch is a touch controlled panel wall switch. It is based on the ESP8285 chip and can control one relay. Behind the blue tape there's a LED which you can control as you like. Other than normal on or off when the ceiling light (or what ever you control with the relay) you might want to flash it on-off-on-off when the morning news paper is delivered to your mailbox.

Hardware

• ESP chip version: ESP8285
• Flash size: 1M
• Onboard USB-TTL converter: No
• GPIO's broken out/available to free use: None
• GPIO tied to onboard hardware: 0 (button), 12 (Relay 2A@230VAC), 13 (LED blue)
• Power supply information: 90-250VAC
• Antenna: onboard PCB antenna

Wiring/flashing

A programmer is needed to flash this device.

(Programmer -> ESP8285):

3.3V -> VCC (first via [square] on board) 
TX -> RX (second via on board)
RX -> TX (third via on board)
GND -> GND (forth via on board)

In order to get the ESP8285 in flash mode the GPIO-0 needs to be LOW. (See picture with explanations below.)

Already soldered board fitted in the casing.

Soldered board seen from front.

Soldered board seen from bottom.

ESP Easy

Devices

---

Switch

---

Relay

---

Switch to Relay rule

 on touch#switch do
  if [touch#switch]=1 do
   gpio,12,1
  else
   gpio,12,0
  endif
 endon 

LED rule

Depending if you want the LED to be on or off when the relay is open/closed you may use this rule:

 on relay#switch do
  if [relay#switch]=1 do  //change this [relay#switch]=0 for LED off when relay is closed
   gpio,13,1
  else
   gpio,13,0
  endif
 endon