Tutorial Domoticz Switch

This tutorial will guide you to connect your first ESP Easy switch to Domoticz. We expect that you have a working Domoticz setup and have loaded the ESP Easy firmware onto your ESP.

Domoticz Menu -> Setup -> Hardware

And add following hardware to you system:

The new hardware should be in the list and there should be a button "Create Virtual Sensors"

Click this button and choose Sensor Type "Switch"

Domoticz Menu -> Setup -> Devices

Your new temperature device should be listed here

Click the little green button with the arrow pointing in the right direction to add this device

Name this device "Demo" and click add device.

Navigate to menu "Switches" and your device should be listed:

If you have your ESP board loaded with ESP Easy firmware, powerup the unit and an Access point named "ESP_0" should appear. Connect to this access point and browse to http://192.168.4.1. If all went well, the following screen should be shown:

Click the "Config" button

Enter your SSID and WPA key and click the "Submit" button

Click the "Tools" button and Click "Connect"

Go back to "Main" and chech the status. It should have an IP address:

Click the "Devices" button

Click the "Edit" button on the first row

Select "Switch Input" and enter the IDX found earlier in Domoticz. In our demo it was 250.

click "Submit" to get additional settings for this device

This should be the final result:

Now toggle GPIO-0 pin high and low and the light bulb in Domoticz should turn on/off accordingly!