Hi @ all,
first thanks for great work !!!
I am a software programmer but I'm a newbie in hardware.
I tried to reproduce the example of the Switch using a NODEMCU v1.0 and espeasy r20.
The settings are like this:
http://www.esp8266.nu/index.php/File:Ea ... Switch.png
The only difference I chose the GPIO-14 instead of GPIO-0
I connected the pin GPIO-14 to ground and the state is changed to "1" in the status page.
I tried to connect it for a second time and something is burned in Nodemcu
Obviously there was a short circuit. Where did I go wrong?
Not all configurable GPIO can be used?
Thank
Pacitzu
Switch Example
Moderators: grovkillen, Stuntteam, TD-er
Who is online
Users browsing this forum: No registered users and 2 guests