Now it is working. Kind of.... Thank you Did what you suggest last. Change the settings in Advance and then config wifi . So it is working the ESP, but not the relay . I setup postman to send msgs and it is working on the ESP . I got 200 OK on postman and in the ESP status I see the relay change, bu...

Hi TD-er, thanks for looking at this. [TD-er]Have you power cycled the board after flashing? [Me] yes [TD-er] Can you clear the ssid password and then connect to the access point started by ESPEasy? Via the console you can set the wifi ssid to "ssid" which indicates it isn't set. [Me] Will...

I have loaded the firmware 20241222_hard LC tech relay_1M from here https://td-er.nl/ESPEasy/ . That went fine and was able to configure my wifi settings. When reboot it never really gets connected to my wifi . This is the console from arduino 2:25:28.652Info : WIFI : Connecting Fibertel 165-2.4Ghz ...

Colleagues, Is there any easy way to find out which plugins are included in which firmware? . All the FW versions are here https://github.com/letscontrolit/ESPEasy/releases Plugins here https://espeasy.readthedocs.io/en/latest/Plugin/_Plugin.html#list-of-official-plugins but how do I correlate them?...

If you can read logs, then the AT commands sent by the module will be parsed by the command interpreter of ESPEasy. This parsing may cause delays, which may affect some time critical actions like connecting to WiFi. The latest builds can be found here: https://github.com/letscontrolit/ESPEasy/relea...

Yes, I am taking power from relay module. Using the breadboard just to make the connections. And yes, also measure the the RX/TX. What I posted up to now is what the module is sending to the local MCU and this is what the MCU is sending (in this case X3)to the ESP8266 and I am assuming it is ignorin...

The voltage should be the same, since I taking the power from the relay module.
Take a look at the picture.

Colleagues, I am working with the LC Tech module 4 relays as HTTP station for openskrinkler app . The issue I am facing is that when the ESP8266 ESp01 is on(attached to) the relay board, it does not connect to the WIFI. If the ESP01 is not installed (since had to remove it to program with ESPEasy) ,...

Check that switch is really working. In my case was the opposite. Never got the blue led, until I bypass the switch. Maybe yours is short circuit....
Regards,

martin