When i open then the ESPEasy config, open the edit dialog for each device, submit it without any change, everything is running well again.
Sounds like a race condition: A spike by the Relay triggers the RCWL-0516. With that action you breack the race.
independent of the radar sensor signal.
Your version shows only after a browser reload the latest state of the RCWL-0516
The latest versions show it automatic in your browser.
Some remarks:
- Your post shows 2 times Device1.jpg .. the relay..., so I don't know your RCWL-0516 settings
- You use GPIO 5, did you switch off the preferred I2C interface for GPIO-5 (see hardware tab)
- RCWL-0516 needs a pull-up resistor internal or external (as far as I understand the scare doc's it is an open collector output with 100 Ohm current limitation resistor)
- RCWL-0516 is extreme sensitive for power fluctuation (like relay on/off), did you add a "power bank" capacitor of around 47uF close to the RCWL-0516 ?
- RCWL-0516 is sensitive for the ESP WiFi transmissions (rather close to the RCWL-0516 frequency), use a 100nF capacitor as spike bypass capacitor as close as possible to the RCWL-0516
30+ ESP units for production and test. Ranging from control of heating equipment, flow sensing, floor temp sensing, energy calculation, floor thermostat, water usage, to an interactive "fun box" for my grandson. Mainly Wemos D1.