The ESPEasy guide doesn't mention the NRF24L01 explicitly but does look similar to the ESP-01 board. So, can the NRF24L01 actually be flashed for ESPEasy?
When attempting to execute the flash on the NRF24L01 (providing COM port, 512 and 120) as input, I get error message...
Code: Select all
Comport (example 3, 4, ..) :7
Flash Size (example 512, 1024, 4096) :512
Build (example 71, 72, ..) :120
Using com port: 7
Using bin file: ESPEasy_R120_512.bin
esptool v0.4.6 - (c) 2014 Ch. Klippel <ck@atelier-klippel.de>
setting board to nodemcu
setting baudrate from 115200 to 115200
setting port from COM1 to COM7
setting address from 0x00000000 to 0x00000000
espcomm_upload_file
stat ESPEasy_R120_512.bin success
setting serial port timeouts to 1000 ms
opening bootloader
resetting board
trying to connect
flush start
setting serial port timeouts to 1 ms
setting serial port timeouts to 1000 ms
flush complete
espcomm_send_command: sending command header
espcomm_send_command: sending command payload
read 0, requested 1
trying to connect...Code: Select all
warning: espcomm_sync failed
error: espcomm_open failed
Press any key to continue . . .USB NRF24L01
Serial
DTR------->SCK
RXD------->CSN
TXD------->
+5v------->
GND------->GND
3V3------->VCC
I've sucessfully uploaded ESPEasy using a NodeMCU board but would like to see what cheaper options with other ESP8266 boards I can use for my temperature array. I'm fairly new to this and am somewhat of a novice when it comes to flashing boards that may need pins swapping over, especially where I can't find guidance on-line. I do have Arduino Nano boards so if this is a better way then please let me know.
Once again, any help or guidance will be appreciated.
