R78 loop reset on ESP8266 12E v3 board

[darek]

After esp v3 upgraded to R78, my board is in reset loop state.

NIT : Booting Build nr:78
WIFI : Connecting... 1
WIFI : Connected!

ets Jan 8 2013,rst cause:4, boot mode:(3,6)

wdt reset
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld
ŞU
INIT : Booting Build nr:78
WIFI : Connecting... 1
WIFI : Connected!

ets Jan 8 2013,rst cause:4, boot mode:(3,6)

wdt reset
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld
ŞU
INIT : Booting Build nr:78
WIFI : Connecting... 1
WIFI : Connected!

I de-assembled all sensors but it is not helped
back to R60 release and board v3 working fine.

NIT : Booting Build nr:60
WIFI : Connecting... 1
WIFI : Connected!
INIT : I2C
MQTT : Connected to broker
Subscribed to: kta4srva/hota/out/
INIT : Boot OK
INIT : RTC not read
WD : Uptime 0 ConnectFailures 0 FreeMem 30880
DS : Temperature: 22.06 (28-ff-65-cb-83-15-1-ed)


what's going on?

[darek]

I solved this problem: back to R60, clear configuration by console reset, update to R78 and write a new config.