Rflinkloader fault

[derksuh]

Hello all,

I’m trying to install the latest version of rflink on my arduino mega, but it won’t program it. When i download a sketch with arduino ide it works fine. With rf link loader i see the following debug.

Serial port test:
Serial port ok
Serial port test done
param: -p atmega2560 -c stk500v2 -P \\.\COM3 -b 115200 -U flash:w: C... location of file on computer.

---------------------------------------
Execute external program:
Exitcode 1
External program ended with an error
Execute external program done
Programming arduino failed
Programming arduino done

[Stuntteam]

are you sure all files from the archive are copied?

[derksuh]

Unpacked the folder again, and now it is working.
Didn’t think about doing that before.

[PeJeWe]

Bij het (her)programmeren van mijn bordje krijg ik de volgende melding:

Code: Select all

Debug mode activated
------------------------------
Programming Arduino:
Port COM4
Filename G:\Downloads\RFLink_v1.1_r48\RFLink.cpp.hex
------------------------------
Serial port test:
Serial port ok
Serial port test done
param: -p atmega2560 -c stk500v2 -P \\.\COM4 -b 115200 -U flash:w:"G:\Downloads\RFLink_v1.1_r48\RFLink.cpp.hex":i
------------------------------
Execute external program:
Exitcode 1
External program ended with an error
Execute external program done

Heb alle bestanden uitgepakt in 1 map.
Het wordt door windows 10 als "Arduino Mega 2560 (COM4) herkend.
Ook de loader als "uitvoeren met admin rechten geprobeerd.

nog ideen?

update:


is de melding die ook nog krijg

[PeJeWe]

I have managed to get it working again by uninstalling the Arduino Mega 2560 windows driver in the windows device manager.
Reinstalled the arduino board.
Restart the RFLink loader and upload/install the RFLink.cpp.hex file.
After that it was up and running again.