My first Domoticz try

[goofman]

Hello,

after reading a lot of this forum I decided to start with Domoticz on a RPi3.
Testsetup : ESP8266-201 with firmware R120, Domoticz on RPI 3.

1st I've flashed the ESP and connected a BMP085 sensor on it, this works.
Now I tried to connect the device with Domoticz;
I've made a dummy sensor and a baro/hum/temp device, noted the IDX.

In the ESP I set this IDX, now it should work, but it doesn't.
When I look at the LOG in the ESP I see that every 10 seconds (my setting) a update of readout is done,
I cannot see in the log the data is send. Is the sending of the values towards domotics visible in de LOG ?

Is there something I've forgotten ?

[goofman]

All,

problem is solved

I 've looked in the wrong column, ID instead of IDX

works perfect !