[SOLVED] INA219, BME280, and Thingspeak Issues

[dirtbikr]

Hi everyone,

My thingspeak channel is located at https://thingspeak.com/channels/183630. I have only received one temperature point, voltage and humidity are operating just fine. My message delay in advanced settings is 15000. The rest of my setup is in the images below:









I cannot figure out why temperature is not being reported, voltage and humidity work flawlessly. It reported a single point, but I don't know how or why. I have tried increasing the message delay to 16000 with no change, and I have played around with the sensor delay settings in the BME280 device (set up to 90) and there was no change. Any ideas? I am running version 120.

EDIT: I'm dumb, had the scale set wrong on Thingspeak.

[dirtbikr]

For the last half hour I have received one update to the temperature every ten minutes, so one is getting through every 10 attempts it seems like. It is also strange that they are exactly on ten minute intervals with no seconds or anything, perfect time divisions?