Difference between revisions of "Configuration"
Jump to navigation
Jump to search
Grovkillen (talk | contribs) |
Grovkillen (talk | contribs) m |
||
| Line 58: | Line 58: | ||
| D11 | | D11 | ||
| | | | ||
| − | | style="background: | + | | style="background: orange; black: white;" | Use with caution!<br/>Reserved for SPI + flash |
|- | |- | ||
| 10 | | 10 | ||
Latest revision as of 12:12, 10 November 2017
This page will tell you more about some things that you may need to know about when using the ESP8266 units (boot states of GPIOs, input voltages, etc. etc). Please beware that this is a generic list, your specific ESP unit might have other restrictions than these general ones. Refer to the ESP Hardware page if you want to be sure what GPIOs that are available and their usefulness.
GPIO on ESP8266
| GPIO Number | GPIO Name | Boot State | Precautions and information |
|---|---|---|---|
| 0 | D3 | HIGH for boot LOW for serial programming |
Pullup resistor on most boards |
| 1 | Used as serial (TX) May be used but observe that signal might flicker due to serial activity during boot. | ||
| 2 | D4 | HIGH for boot HIGH for serial programming |
Connected to onboard LED (low active) Used as serial1 (TX1) |
| 3 | Used as serial (RX) May be used but observe that signal might flicker due to serial activity during boot. | ||
| 4 | D2 | Generally used as SDA (I2C) | |
| 5 | D1 | Generally used as SCL (I2C) | |
| 6 | Do not use! Reserved for SPI + flash | ||
| 7 | Do not use! Reserved for SPI + flash | ||
| 8 | Do not use! Reserved for SPI + flash | ||
| 9 | D11 | Use with caution! Reserved for SPI + flash | |
| 10 | D12 | Use with caution! Reserved for SPI + flash | |
| 11 | Do not use! Reserved for SPI + flash | ||
| 12 | D6 | ||
| 13 | D7 | ||
| 14 | D5 | ||
| 15 | D8 | LOW for boot | Pulldown resistor on most boards |
| 16 | D0 | No PWM (counter not possible). No internal pullup available. Used in sleep mode for wakeup |
