Where do you see screenshots above? Have you checked the log, if there is something to see what the reason could be? DEVICES https://i.imgur.com/MEmbCZN.jpg LIGHTSWITCH https://i.imgur.com/o4suS5Z.jpg RULE on lightSwitch#Switch do if [lightSwitch#Switch]=0 gpio,12,1 else gpio,12,0 endif endon

I tried using the event and it behaves the same, it turns on and stays on for some 5/6 seconds and then turns off

The button works, it stays on for approx 5 seconds and then it automatically turns off

There is only one rule and is the one posted above, config screenshots are the ones above

I see what you did there and I get it, but still it doesn't work..

I tried both and didn't make a difference

In the past someone posted a rule to enable the switching ON/OFF by pressing the button on Sonoff 10A but for some reason the rule partially works meaning that it turns on the light but then it automatically turns it off after some seconds and I do not understand why.... in ESP EASY v 12 I have the ...

Thanks a lot, this post made the trick!
viewtopic.php?f=5&t=3386&hilit=DOUT&start=10#p18240

I just flashed ESPEasy2 dev11 on new Sonoff Model 10A and cannot see ESP_Easy_0; what am I doing wrong?

That made it, thanks!!!

Hello I flashed ESPEasy v 148 onto Sonoff plugs and I am able to control them via OpenHab2/MQTT; however I would like to be able to manually switch on/off by pressing the little button on the plug; is it possible? If yes, how? Hereafter my devices config: https://preview.ibb.co/fOoFVk/devices.png Th...