Sonoff Switch with ESPeasy

[corederoma82]

Hi guys,
I have a sonoff switch that I have uodated with EaspEasy firmware.
It seems work because when I push the sonoff button, in software the status became 1 and if I re-push the button the status became 0.
I have problem when I connect the Sonoff Switch at my boiler; the voltage is ok, the Sonoff is on and work but when I press the switch button the led boiler is always swtich off.

Thanks

[grovkillen]

You need to tell the FW what to do when the switch is pushed. See this guide for the Touch:

https://www.letscontrolit.com/wiki/inde ... noff_Touch

We haven't completed a guide for the Sonoff Basic but you get the general idea.

[corederoma82]

thank you for your support but where must I insert the rule?
are you sure that problem is this? i means....rele seems ok with status 1 and 0 when I push button but seems that circuit remains always open.

[grovkillen]

But how would the relay know that it should act on the switch? This is not a specific FW for Sonoff but a generic FW for "all" ESP 8266/8285.

Regarding where to put the rule, please study the wiki.