Login Webinterface

[Miki]

Hi, where can I find the password for Web login?
Or where can I adjust that?

In the esp easy sketch I could not find a config for it.
I flashed the R48 and configures the ESP-01. After a second reboot the Login Windows appeared.

Greetz Miki

[costo]

If you are talking about the Access-Point webgui on 192.168.4.1 this has a default password, which is defined in the beginning of the main program:

#define DEFAULT_AP_KEY "configesp"

If you leave it empty, you will need no password.

[mkotek]

And if you are talking about admin password for configuration, it is being set in the Config tab and I have not seen ability to prepopulate it via content of INO.

But if you are getting a fully blown Windows login form (as a popup, not HTML form with place to enter password) when entering IP of the ESP, that means, something else is using this IP.

[Miki]

Hi costo, and mkotek,

it´s the admin pasword for the configuration.

please, look at the screens.

[mkotek]

So this password is being set as Admin Password on Config tab. It must have survived your previous experiments, so you need to use a clean flash procedure mentioned here: http://www.esp8266.nu/forum/viewtopic.p ... =466#p2412

[Martinus]

Just try 'reset' command using serial port. Should be sufficient to clear the config.

[Miki]

Thank You mkotek,

that worked for me.