esp easy connecting to home network

[Tim-]

Hello,

First all the necessary information:

Arduino version 1.6.5
i used the: ESP8266-07

Connected: GND - GND
GPIO15 - GND
GPIO2 - 3.3V
GPIO0 - 3.3V
EN - 3.3V
VCC - 3.3V

DS18B20 connected:
GND - GND
VOD - 3.3V
DQ - GPIO12

the problem:

I followed this tutorial:
http://www.esp8266.nu/index.php/Tutoria ... are_Upload

after flashing ESPEasy R048 i configured the esp8266 so that it is connected to my home-network.
But if i add the DS18B20 to the Device list. The esp8266 disconnects from my home-network and appears in the network selections as an stand-alone network and is it only accesible by 192.168.1.4.

What is the best way to connect and configure this so it is accesible in my home-network.

[tozett]

maybe you want to give the lastest firmware a try?
dont know, but maybe your problem is already solved since R048 to R078?

here latest stable:
http://www.esp8266.nu/index.php/Main_Page#Stable

[Tim-]

i will give that a try

i heard that if i am gonna use this firmware i don't have to flas the esp8266 but how do i put the right firmware on the esp?

never mind i know i have to use the flash tool

[Tim-]

it works

The esp is now connected to my network and the ds18b20 is added by the device list.

Now i can figure out how the ds18b20 will display the right temperature instead of 0.00.

thanks!

[tozett]

seems SOLVED here...

[Backbone]

Now i can figure out how the ds18b20 will display the right temperature instead of 0.00.

Place IDX number other then zero 0.

[tozett]

if this is the reason, than you are another one how stumpled upon this idx-feature
sometimes i wished me a clearer gui for reading+sending/not sending

http://www.esp8266.nu/forum/viewtopic.p ... ding#p3687

[Tim-]

It is already solved

i figured out the picture with the pinout was backwards and the pins were connected to the wrong pin

but thanks for helping!