hi,

you need to use a clean flash procedure mentioned here: http://www.esp8266.nu/forum/viewtopic.p ... =466#p2412

DHT11 or DHT22?

Over which GPIO Pin the DHT is connected? Can you post a screen from ur Device Config?

Thx

hmm,

i connected VCC and GND from a 5V Power supply, Trig direct on D5 of my nodmcu and Echo with the 10k resitor on D8.

http://www.esp8266.nu/forum/download/fi ... iew&id=195

Hi, if the mode is set to "State" the SR-04 will only Show 0 or 1. If the mode ist set to "Value" it will show Centimeters. But if the "Sensor Delay" ist set to 60, it will update the Centimeters every 60 Seconds. I´m using a 10k resistor connected on Echo, on my nodemc...

Thank You Martinus.

If i don´t use a Controller (in my Lab Environment), can i deactivated it in the espeasy config?
0 for no Controller?

Same Problem here. The nodemcu Board restarts every 30min. ESP core 2.0.0 build #48 It is stable for ~30min. Then the webinterface is not rechable and in the Serial Monitor this appears: HTTP : connection failed WD : Uptime 31 ConnectFailures 30 FreeMem 26624 WD : Uptime 32 ConnectFailures 30 FreeMe...

Thank You mkotek,

that worked for me.

Hi costo, and mkotek,

it´s the admin pasword for the configuration.

please, look at the screens.

Hi, where can I find the password for Web login?
Or where can I adjust that?

In the esp easy sketch I could not find a config for it.
I flashed the R48 and configures the ESP-01. After a second reboot the Login Windows appeared.

Greetz Miki